This device makes it possible to perform modern acupuncture without a needle and therefore legally. It not only acts via an electric current on acupuncture points, but also detects their location. You can adjust the current in intensity but also in frequency which corresponds to the way you handle a needle. It comes with 3 touch points: a fine one for auriculotherapy work, a normal one for all skin acupuncture points and a third spatula-shaped for skin tightening or drainage work. The tip is spring loaded to ensure constant pressure on the point. The mass is located on the device. In the case of use on another person, a manual weight gain that the person will have to hold, is connected to the device. It will then be appropriate, especially for detection, to avoid being in contact with the skin of the person with the other hand. The detection value is displayed on the device, but also makes it possible to estimate it thanks to an ingenious sound signal, the frequency of which is proportional to the measurement. The device is equipped with a rechargeable lithium battery on a USB port (charger supplied).
The device can also be used in Voll's electro acupuncture based on the drop in value on the measurement and control points. It thus replaces to a certain extent the MF1 and MF2 devices which are obsolete (see the EAV part in documentation). Being in contact with a suitable homeopathic remedy (or via a scanned product from the homeopathy software database) helps restore the loss. It is then used as a test for homeopathic (or other) products. To use this functionality with the digitized base, you will need to add with the device, the homeopathy software, as well as Ear connection clips that you will find in the shop section. To best appreciate the drop of a point, you will have to set the device to a low level of detection sensitivity (graduation 4 approximately). When a point shows a real fall, it manifests quickly. The measurement should therefore not exceed 2 seconds on a point in order to avoid false interpretations. The point with a strong drop will then become the representative of the fact that a product in contact corrects the drop (and often other drops if they exist). The most significant remains the twenty measurement and control points given in the EAV part of the documentation. A minimum of training will allow you to best judge the settings and the appreciation of the measurements.
To order it, go to the section Store of the Website.